Abstract
AbstractTwo soil acidulents were compared for their effects on soil chemical and mineralogical properties. Aluminum sulfate [Al2(SO4)3 · 18 H2O] powder was applied at rates of 0.13, 0.26, 0.52, and 1.05 kg m−3 (7.5, 15.0, 30.0, and 60.0 g per pot, respectively). Elemental S powder was added at rates of 0.03, 0.06, 0.13, and 0.26 kg m−3 (1.9, 3.8, 7.5, and 15.0 g per pot, respectively). Sawdust was incorporated into the soil at rates of 0, 20, 40, and 60 m3 m−3 (% by volume). The soil used in this experiment was a previously limed sandy loam surface from a Typic Hapludult with an initial pH of 6.2. On a mass basis, approximately eight times as much Al2(SO4)3·18 H2O as elemental S was needed to cause a two‐unit decrease in soil pH. The acidity produced by S maintained low pH longer than Al2(SO4)3·18 H2O. Extractable levels of Ca and Mg in the highest acidulent treatments were approximately double that of the controls at the conclusion of the experiment. This is a probable response to lime particles from a previous liming being dissolved by acids. Extractable K, because of destruction of illitic clay minerals, was significantly higher in the S treatments than in the Al2(SO4)3 treatments or controls. Extractable Al levels were greater than the controls only at higher rates of both acidulents. Extractable Al levels at a given pH were higher in the Al2(SO4)3‐treated soils than in those treated with S. Destruction of clay minerals, including gibbsite, kaolinite, and hydroxy interlayered vermiculite were evident in the highest S treatment, even though both the Ca/Mg and K/NH4 cation exchange capacity values increased when compared to the controls. Aluminum sulfate had little effect on clay mineral stability when compared to the controls, and may have increased the heat stability of K saturated hydroxy interlayered vermiculite.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.