Effects of skin preapplication treatments and postapplication cleansing agents on dermal absorption of 2,4‐dichlorophenoxyacetic acid dimethylamine by Fischer 344 rats

Abstract

Various methods of preparing dermal application sites in Fischer 344 rats prior to exposure to 2,4-dichlorophenoxyacetic acid dimethylamine salt (2,4-D amine) and the effect of various cleansing agents following exposure were examined by measuring recoveries of 14C-labeled 2,4-D amine in skin, postapplication cleansing solution, blood, and urine. The middorsal area of the rat was the site of application for four treatments tested: (1) hair clipping only, (2) hair clipping followed by an epilatory cream, (3) hair clipping plus shaving with an electrical razor, and (4) as in treatment 3 followed by washing with soap and water. A last preparation was the rat's tail thoroughly brushed with soap and water. The results indicated that the tail retained greater than 75% of the material, thus preventing its absorption into the blood stream and subsequent removal by cleansing. With treatment 1 the dense short hair remaining after clipping impaired the absorption of 2,4-D as evidenced by considerably lower blood and urinary levels than treatments 2-4. With preparations 1-4, 45-61% of the dose was removed with the 7-h postapplication cleansing and a further 5-6% with the subsequent 23-h cleansing. In other studies using preparation 3 above, the following cleansing agents were tested: soap and water, water, isopropanol, acetone, and Rad-Con, a foam-producing cleanser. Rad-Con removed more 2,4-D from the skin than other cleansing agents after 7 h of exposure and more than soap and water after 23 h. The percentages of 2,4-D left on the skin following either 7- or 23-h cleansing with Rad-Con were 8-12%, nearly half those following the other cleansing agents. Cleansing agents other than Rad-Con presented little advantage over soap and water. With all cleansing agents, delaying cleansing from 7 to 23 h after exposure resulted in higher blood and urinary levels of 2,4-D measured 24 h after application.