Effects of Shock Wave Development on Secondary Flow Behavior in Linear Turbine Cascade at Transonic Condition

Abstract

Abstract Gas turbines widely applied to power generation and aerospace propulsion systems are continuously enhanced in efficiency for the reduction of environmental load. The energy recovery efficiency from working fluid in a turbine component constituting gas turbines can be enhanced by the increase of turbine blade loading. However, the increase of turbine blade loading inevitably intensifies the secondary flows, and consequently increases the associated loss generation. The development of the passage vortex is strongly influenced by the pitchwise pressure gradient on the endwall in the cascade passage. In addition, a practical high pressure turbine stage is generally driven under transonic flow conditions where the shock wave strongly influences the pressure distribution on the endwall. Therefore, it becomes very important to clarify the effects of the shock wave formation on the secondary flow behavior in order to increase the turbine blade loading without the deterioration of efficiency. In this study, the two-dimensional and the three-dimensional transonic flows in the HS1A linear turbine cascade at the design incidence angle were analyzed numerically by using the commercial CFD code with the assumption of steady compressible flow. The isentropic exit Mach number was varied from the subsonic to the supersonic conditions in order to examine the effects of development of shock wave caused by the increase of exit Mach number on the secondary flow behavior. The increase of exit Mach number induced the shock across the passage and increased its obliqueness. The increase of obliqueness reduced the cross flow on the endwall by moving the local minimum point of static pressure along the suction surface toward the trailing edge. As a consequence, the increase of exit Mach number attenuated the passage vortex.