Abstract
Electrical noise interference in low-level (approximately 50 ..mu..V), wide band (approximately 15 MHz) flux monitoring systems applied to nuclear reactor control causes safety and reliability problems. Others have shown that one predominant source of noise interference is conduction of currents in instrument cable shields and building conduits. Since these currents produce noise that is similar to signals produced by nuclear detectors, such noise interference reduces the ability of a reactor instrumentation system to determine the condition of a reactor. Model equations of ground noise interference were derived for a system model consisting of a sensor, coaxial cable, and an amplifier. These equations describe the effect of ground impedance, sensor impedance, transfer impedance, and connector resistance on both low-frequency (less than 100 kHz) and high-frequency (greater than 100 kHz) ground noise interference. Other model equations were derived for a system with a coaxial balun (a flexible coaxial cable wound around a ferrite core) added between the sensor and the sensor amplifier input. Analysis of the model equations reveals the effects of ground noise currents on instrumentation systems and the conditions for minimizing ground interference.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
