Effects of sheet flow rate and slope gradient on sediment load

Abstract

Sheet erosion is known as one of the most important forms of erosion, particularly in agricultural land. The purpose of this study was to investigate the effect of flow rate and slope gradient on runoff and sediment discharges in two different soils. Experiments were conducted using a tilting flume facility with the test area of 0.2 × 1.0 m. Overall, 24 experiments on two soils (clay loam and sandy clay loam textures) including six flow rates (75, 100, 125, 150, 175, and 200 ml/s) and two slope gradients (1.5 and 2 %) were performed. The selected flow rates and flume slopes were generated to simulate sheet erosion. The results showed that for both soils and slopes, unit flow discharge (q) and sediment concentration increased with increasing flow rate; however, the effect of slope gradient on flow discharge depends on soil type. In addition, sandy clay loam exhibited higher values of q and sediment concentration and consequently, it showed greater amounts of sediment load. At the start of event, sediment concentration was high but it decreased to approach a steady state. In addition, the time needed to reach a steady state condition was shorter for sandy clay loam than that for clay loam soil and in lower flow rates than higher flow rates. For each soil and slope, there was a direct relationship between sediment load and flow rate. The result implied that the effect of slope gradient on sediment load was almost greater in sandy clay loam soil than clay loam soil. Moreover, the differences between sediment loads of two soils are enlarged at slope 2 %.