Abstract
Currently, joint sealant is designed without consideration of the bond strength between the concrete and the sealant and the effect of shape on stress concentration. This often leads to adhesive failures within 1.5 years, earlier than the expected service life of the joint sealant, which is 20 years. In adhesive failure, the strength of the bond and the stress of the interface between the sealant and the face of the joint reservoir play a very important role. To examine the nature of the bond along the sealant/joint well interface, experimental bond tests were conducted. In addition, the stress distribution on the interface was also investigated according to geometry (Shape Factor [SF] and degree of curvature [DoC]). Re-evaluation of the SF was conducted, and a new design factor, DoC, was introduced and investigated through the finite element method of analysis. With these factors, the reduction of bond strength and increase in the stress at the interface can be limited reducing the potential for early adhesive failure. Based on this study, the effect of joint preparation (dirt and moisture) on joint strength and shape (SF and DoC) of joint sealant should be considered when designing and installing sealants.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Transportation Research Record: Journal of the Transportation Research Board
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
