Effects of Root Canal Curvature and Mechanical Properties of Nickel-Titanium Files on Torque Generation

Abstract

IntroductionThis study aimed to compare the torque generated by 4 different files in root canals with 4 different curvature angles. MethodsFour brands of nickel-titanium (NiTi) endodontic files were selected: WaveOne Primary (Dentsply Sirona, Ballaigues, Switzerland), WaveOne Gold Primary (Dentsply Sirona), ProTaper Universal F2 (Dentsply Sirona), and ProTaper Next X2 (Dentsply Sirona). A tempered steel block containing artificial canals with 4 different canal curvatures (15°, 25°, 35°, and 45°) was constructed. Each file was used according to the manufacturer’s instructions in the dynamic model, with an added 15 axial up-and-down movements of 4 mm at the end of the canal. The generated torque was recorded, and the total and maximum torque values were measured. Two-way analysis of variance and the Duncan post hoc comparison test were performed at a significance level of 95%. ResultsA significant correlation between the curvature angle and the type of file system was observed (P < .05). As the degree of canal curvature increased, the generated total and maximum torque increased. At 15° and 25°, the NiTi files with reciprocating motion generated a higher total and maximum torque than files with continuous rotation. ProTaper Universal of conventional NiTi alloy showed the steepest increase in the generated total and maximum torque with the increasing curvature angle. The ProTaper Next file had the lowest torque values at the higher canal angles of 35° and 45° (P < .05). ConclusionsDespite the study limitations, it can be concluded that root canal curvature, design, and heat treatment of NiTi files and file kinematics affect the generated torque during instrumentation.