Effects of Replacement of Part of the Silica Reinforcement with Hybrid Modified Microcrystalline Cellulose on the Properties of their Rubber Composites

Abstract

ABSTRACTHybrid modified microcrystalline cellulose (HMCC), with SiO2 nanoparticles being in-situ loaded on the surface of microcrystalline cellulose (MCC), was obtained through a sol-gel process of tetraethoxysilane (TEOS) by using ammonia as catalyst. HMCC was characterized by thermogravimetric analysis and scanning electron microscopy. The results showed that the spherical nano-SiO2 particles had been loaded successfully on the surface of the MCC with a loading ratio of approximately 10%. Then the HMCC was used in high vinyl solution-polymerized styrene butadiene rubber (SSBR)/silica compounds to replace part of the silica, and its effects on the physio-mechanical and dynamic mechanical properties of the vulcanizates were investigated. The results showed that the HMCC samples had improved physio-mechanical properties and lower heat build-up than that of MCC ones. Dynamic mechanical analysis (DMA) showed that the tanδ value of the compounds decreased at 60°C while increased obviously at 0°C, which meant that the tires would have improved wet-skid resistance while maintaining low rolling resistance when HMCC was used in tire tread compounds. As observed from scanning electron microscopy (SEM) photos, the sizes of the HMCC were in-situ decreased from 20–90 µm to 0.5–10 µm during the processing of the rubber compounds. Compared with MCC, the interfacial adhesion between HMCC and rubber was also improved greatly.