Effects of reactive reinforced interface on the morphology and tensile properties of amorphous polyamide-SAN blends

Abstract

The effects of reactive reinforced interface on the morphology and tensile properties of amorphous polyamide (a-PA) and styrene-acrylonitrile (SAN) copolymer blend have been investigated using styrene maleic anhydride (SMA) copolymer as a reactive compatibilizer. The anhydride groups of SMA copolymer can react with the amine groups of polyamide and form in situ graft copolymers at the a-PA–SAN interfaces during the blend preparation. The interfacial adhesion strength of the reactive reinforced interface was evaluated quantitatively using an asymmetric double cantilever beam fracture test as a function of SMA copolymer content using a model adhesive joint. The interfacial adhesion strength was found to increase with the content of SMA copolymer and then level off. The morphological observations of a-PA–SAN (80/20 w/w) blends showed that the finer dispersion of the SAN domains with rather narrow distribution was obtained by the addition of SMA copolymer into the blends. The trend of morphology change was not in accord with that of the interfacial adhesion strength with respect to the content of SMA copolymer. However, the results of tensile properties showed very similar behavior to the case of the interfacial adhesion strength with respect to SMA content; that is, there was an optimum level of the reactive compatibilizer beyond which the interfacial adhesion strength and tensile strength did not change significantly. These results clearly reveal that tensile properties of polymer blend are highly dependent on the interfacial adhesion strength. Furthermore, it is suggested that the asymmetric double cantilever beam fracture test using a model interface is a useful method to quantify the adhesion strength between the phases in real polymer blends. © 1998 John Wiley & Sons, Inc. J Appl Polym Sci 68: 1925–1933, 1998