Abstract
This work investigated the potential to achieve zinc oxide (ZnO) films for Cu2ZnSnS4 (CZTS) solar cells window layer at controlled annealing conditions as a potential approach to address elemental inter-diffusion in CZTS solar cells. This involved rapid thermal annealing (RTA) of room-temperature oxygenated DC sputtered zinc thin films in an ambient of nitrogen gas at different temperatures. Structural, morphological, optical, and electrical properties of these films were determined by X-ray diffractometer, Scanning Electron Microscopy, Ultraviolet-visible-near infrared spectrophotometer, and Hall Effect measurement, respectively. ZnO phases were observed after annealing the films over 150 °C. The films’ grains sizes improved with increasing RTA temperature. An exponential decrease in these films’ resistivity was observed with increasing RTA temperature attaining the lowest value at 300 °C. The bandgap and average solar transmittance of the films increased with increasing RTA temperature achieving values that are potential for applications in CZTS solar cells window layer at RTA temperatures beyond 200 °C.
 Keywords: Sputtering; Rapid thermal annealing; Zinc oxide; Structural; Opt-electrical
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
