Abstract
ABSTRACTCharacteristics of Cu/C:H films on the PET substrate prepared by ECR-MOCVD coupled with a DC bias under Cu(hfac)2-Ar-H2 was investigated with special attention to process parameters. Our results showed that the Cu/C:H film has strongly adhere with the polymer substrate by chemical bonding and exhibited wide range of electrical conductivity that could be controlled by process parameters. The increase in H2/Ar ratio, microwave power and negative DC bias voltage brought on the higher pulling strength between Cu/C:H films and PET substrate. The effects of surface pretreatments of polymer substrate on pulling strength were insignificant in the range of our experimental range.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.