Effects of Posterior Tibial Slope on a Posterior Cruciate Retaining Total Knee Arthroplasty Kinematics and Kinetics

Abstract

BackgroundIt has been hypothesized that increasing posterior tibial slope can influence condylar rollback and play a role in increasing knee flexion. However, the effects of tibial slope on knee kinematics are not well studied. The objective of this study is to assess the effects of tibial slope on femorotibial kinematics and kinetics for a posterior cruciate retaining total knee arthroplasty design. MethodsA validated forward solution model of the knee was implemented to predict the femorotibial biomechanics of a posterior cruciate retaining total knee arthroplasty with varied posterior slopes of 0°-8° at 2° intervals. All analyses were conducted on a weight-bearing deep knee bend activity. ResultsIncreasing the tibial slope shifted the femoral component posteriorly at full extension but decreased the overall femoral rollback throughout flexion. With no tibial slope, the lateral condyle contacted the polyethylene 6 mm posterior of the midline, but as the slope increased to 8°, the femur shifted an extra 5 mm, to 11 mm posterior of the tibial midline. Similar shifts were observed for the medial condyle, ranging from 7 mm posterior to 13 mm posterior, respectively. Increasing posterior slope decreased the posterior cruciate ligament tension and femorotibial contact force. ConclusionThe results of this study revealed that, although increasing the tibial slope shifted the femur posteriorly at full extension and maximum flexion, it reduced the amount of femoral rollback. Despite the lack of rollback, a more posterior location of condyles suggests lower chances of bearing impingement of the posterior femur and may explain why increasing slope may lead to higher knee flexion.