Abstract
Earth-abundancy, nontoxic constituent, along with excellent stability and optoelectronic properties make antimony selenide (Sb2Se3) one of the potential candidate for low cost photovoltaics. In this work, antimony selenide (Sb2Se3) thin films were prepared by low temperature thermal evaporation method and characterized. Solar cells were fabricated in the superstrate configuration of Glass/ITO/ZnO/CdS/Sb2Se3/Au. It was found that annealing in vacuum after Sb2Se3 deposition played a significant role in the device performance. One-dimensional crystal structure of Sb2Se3 with a preferred grain orientation was found to be beneficial for the higher performance of the solar cells with vacuum annealing at 300 °C. Furthermore, Cu addition after the deposition of Sb2Se3 was introduced to improve the back contact and the device performance. In particular, Cu addition as a back contact leads to a significant increase in the Voc and the fill factor (FF). Moreover, aging of the finished cells during accelerated stability tests revealed a light soaking effect without degradation even in case of copper insertion. Our best solar cell showed a conversion efficiency of 3.5% without selenization.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.