Effects of polymer solvents on the performance of cellulose acetate membranes in methanol/methyl tertiary butyl ether separation

Abstract

AbstractThe performances of cellulose acetate membranes prepared with casting solutions, with acetone, dimethylformamide (DMF), and N‐methylpyrrolidone (NMP) as solvents, were studied in a series of methanol/methyl tertiary butyl ether separation experiments. The flux and selectivity of the membrane samples were affected by the type of solvent used to prepare the casting solution. The sample with DMF consistently gave the highest selectivity and lowest flux, followed by the samples with NMP and acetone. The differences in the performances were attributed to the effects of the volatility and evaporation rates of the solvents. Scanning electron microscopy and atomic force microscopy techniques were used for comparing the morphologies of the membranes. In addition, we used Raman spectroscopy as a novel technique to study the sorption selectivities of the membrane samples prepared with the three different solvents. In a parallel study, the relation between the polymer concentration in the casting solution and the morphology and performance of the membrane samples was studied. Under similar preparation conditions, the morphology of the membrane changed from being porous to being dense when the membrane was prepared with casting solutions with increasing polymer concentration. Also, the selectivity increased and the permeability decreased with increasing polymer concentration in the casting solution. © 2001 John Wiley & Sons, Inc. J Appl Polym Sci 82: 2882–2895, 2001