Abstract

Compact bone makes up approximately 80% of the human skeleton by mass; but there are little data available on the effects of increased bone turnover on compact bone mechanical and material properties. This study addresses this question by measuring intracortical remodeling, resorption cavity number, and porosity in an ovariectomized (OVX) sheep model, and measures changes in biomechanical properties. Thirty-eight sheep were divided into two groups. Group 1 were controls (n = 19), and Group 2 were ovariectomized (OVX; n = 19). Fluorochrome dyes were administered intravenously to both groups at five time points over 12 months post-OVX to label sites of bone turnover. At 12 months post-OVX all animals were euthanized. Samples were harvested from the left metatarsal and were analyzed for intracortical bone turnover at five time points, the number of resorption cavities, and the level of intracortical porosity. The effects of these parameters on bone biomechanical properties were then measured. Bone turnover was increased in the OVX group at 6, 9, and 12 months (p < 0.05). Resorption was also higher in the OVX group at 12 months (p < 0.05). Furthermore, porosity was significantly increased in the OVX group at 12 months (p < 0.05). Stiffness and yield strength were reduced in the OVX group compared to controls (p = 0.05). Ultimate compressive strength and work to fracture did not differ between groups. These findings provide new insights into the mechanisms and effects of increased bone turnover on bone material and microstructural properties.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.