Abstract

This study examined the effects of OH concentration and temperature on the NO emission characteristics of turbulent, non-premixed methane (CH4)/ammonia (NH3)/air swirl flames in two-stage combustors at high pressure. Emission data were obtained using large-eddy simulations with a finite-rate chemistry method from model flames based on the energy fraction of NH3 (ENH3) in CH4/NH3 mixtures. Although NO emissions at the combustor exit were found to be significantly higher than those generated by CH4/air and NH3/air flames under both lean and stoichiometric primary zone conditions, these emissions could be lowered to approximately 300 ppm by employing far-rich equivalence ratios (ϕ) of 1.3 to 1.4 in the primary zone. This effect was possibly due to the lower OH concentrations under far-rich conditions. An analysis of local flame characteristics using a newly developed mixture fraction equation for CH4/NH3/air flames indicated that the local temperature and NO and OH concentration distributions with local ϕ were qualitatively similar to those in NH3/air flames. That is, the maximum local NO and OH concentrations appeared at local ϕ of 0.9, although the maximum temperature was observed at local ϕ of 1.0. Both the temperature and OH concentration were found to gradually decrease with the partial replacement of CH4 with NH3. Consequently, NO emissions from CH4/NH3 flames were maximized at ENH3 in the range of 20% to 30%, after which the emissions decreased. Above 2100 K, the NO emissions from CH4/NH3 flames increased exponentially with temperature, which was not observed in NH3/air flames because of the lower flame temperatures in the latter. But, the maximum NO concentration in CH4/NH3 flames was occurred at a temperature slightly below the maximum temperature, just as in NH3/air flames. The apparent exponential increase in NO emissions from CH4/NH3 flames is attributed to a similar trend in the OH concentration at high temperatures.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call