Effects of non‐condensable CCUS impurities (CH4, O2, Ar and N2) on the saturation properties (bubble points) of CO2‐rich binary systems at low temperatures (228.15–273.15 K)

Abstract

AbstractThe present work investigated the effects of some non‐condensable impurities (i.e., N2, O2, CH4, and Ar) on the phase behaviour of CO2‐rich systems at low temperature conditions (228.15–273.15 K). The study focused on bubble point measurements of CO2‐rich systems using the isothermal (pressure–volume) method at different mole fractions of CO2 (99.5%–95%). The obtained experimental data were used to validate multi‐fluid Helmholtz energy approximation (MFHEA) and Peng–Robinson (PR) equations of state (EoSs). For all data points, the measurements’ uncertainties for temperature and pressure were 0.14 K and 0.03 MPa, respectively. While the composition uncertainty of the CO2 systems was a maximum of 0.024%. The findings reveal that as the mole fractions of the impurities increased, the bubble point pressures of the binary mixtures were elevated. Among all the investigated impurities, N2 has the most significant effect on the bubble point pressures of CO2 binary mixture at all the isotherms and compositions. Both MFHEA and PR models agreed well with the measured equilibrium points. For all systems, the average absolute deviations of the measured experimental data against the MFHEA and PR EoSs, were found to be less than 3.4% and 2.2%, respectively. Although the MFHEA EoS overpredicted most of the data points, the overall trend agreed with the experimental data and was consistent with the data available in the literature. The findings imply that the presence of these non‐condensable impurities (even as low as 0.5% mole fraction) increases the risk of two‐phase flow at higher pressures in a CO2‐rich system. © 2023 The Authors. Greenhouse Gases: Science and Technology published by Society of Chemical Industry and John Wiley & Sons Ltd.