Effects of Nitrogen Content on the Structural, Mechanical, and Corrosion Properties of ZrN Thin Films Grown on AISI 316L by Radiofrequency Magnetron Sputtering

Abstract

AbstractZirconium nitride films are deposited onto stainless steel AISI 316L and silicon (100) by radio frequency magnetron sputtering at different nitrogen flow ratios [N2/(Ar+N2)] varied between 0 and 0.25). Scanning electron microscope, atomic force microscopy, X‐ray diffraction (XRD), and Raman are used to investigate the surface morphology and microstructure of the thin films. The mechanical and electrochemical properties of all coatings are evaluated and compared with the uncoated AISI 316L to explore the efficiency of surface modification. The XRD and Raman analysis show that all the films are crystalline. This shows that the increased nitrogen content leads to a transformation from hexagonal α‐Zr phase to cubic c‐Zr and then to mixed α‐Zr and face centered cubic c‐ZrN phases. The films deposited with nitrogen flow ratio of 0.2 show the highest hardness of 32.2 GPa. Using the potentiodynamic polarization method, the corrosion behavior of the films is studied in Hank's solution. The comparison between uncoated and coated substrates shows a decrease in corrosion current density for all coated samples.