Abstract

Clean machining is gaining ground as one of the crucial issues in future manufacturing. Many machining industries are looking for alternative solutions to wet machining because of the costs of the latter, including environmental costs, as well as its impact on occupational health and safety. Dry machining is being proposed, but in most conditions, the cutting tool wears out quicker, leading to part quality deterioration and increased machining costs. Minimum quantity lubrication (MQL) machining is also proposed to maintain a reasonable tool life and limited cost, as compared to the situation with flood or wet machining. Both the MQL and dry machining methods, however, are susceptible to the generation of aerosols containing metallic particles that can be detrimental to occupational health and safety. Minimizing particle emissions is of prime importance since these can have serious consequences on the operator’s health. They have been seen to be at a minimum at two specific cutting ranges. In this study, investigations are done to examine the effect of lubrication (dry and MQL) during the turning of the 7075-T6 aluminum alloy. The performance indexes studied are the surface roughness, the chip thickness, and aerosol generation.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.