Abstract
Pool boiling experiments using horizontal, flat, and upwards facing aluminum, stainless steel, and copper, heating surfaces are conducted in distilled water. The wettability, measured by the static contact angle (CA), and the critical heat flux (CHF) are found to vary significantly among the three surfaces. The Boehmite treated aluminum, stainless steel, and copper surfaces have a CHF of 1850, 1375, and 1015 kW/m2, respectively. Powder Injection Molding (PIM) and High-Temperature Conductive Microporous Coating (Cu-HTCMC) are also applied on the copper heating surface to create various microstructures, and their pool boiling performances are compared to that of a plain copper surface. The PIM and Cu-HTCMC reduce the contact angle and increase the CHF value. However, the Cu-HTCMC causes an increase in CHF well beyond the expected value, and it is believed to be due to the porous coating structures and reentrant type cavities within the microporous coating.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
