Effects of Manufactured Sand and Steam-Curing Temperature on the Compressive Strength of Recycled Concrete with Different Water/Binder Ratios.

Abstract

New building materials (manufactured sand and recycled coarse aggregates) can conserve raw materials and protect the environment. Prefabricated members can shorten the construction time of a structure. To use manufactured sand and recycled coarse aggregate in the preparation of precast member concrete, an economical and practical steam-curing scheme must be developed such that the compressive strength of precast manufactured sand recycled concrete (MRC) meets the requirements for hoisting. The effects of different steam-curing temperatures (standard curing, 40 °C, 50 °C, 60 °C, 70 °C, and 80 °C) on the compressive strength of MRC with three water/binder ratios (W/B) (0.46, 0.42, and 0.38) were studied. In addition, the microstructure of MRC was examined using a scanning electron microscope. The equivalent age-compressive strength model was used to estimate the recycled concrete with manufactured sand. The results showed that the strength of MRC with a water-cement ratio of 0.46, 0.42, and 0.38 reached 33.9, 38.7, and 45.1 MPa, respectively, after 28 days of standard curing. The results also indicated that an increase in the steam-curing temperature had a positive effect on the early compressive strength of MRC and a negative effect on the 28 d compressive strength. This behavior was more obvious for MRC with a low W/B ratio. For MRC with a W/B of 0.46, 0.42, and 0.38, after steam-curing for 6 h, the compressive strength reached 32-65%, 36-70%, and 40-77% of the design strength, respectively. The optimum steam-curing temperatures for MRC with W/B of 0.46, 0.42, and 0.38 were 60 °C, 60 °C, and 50 °C. A decrease in W/B has a negative impact on the accuracy of MRC estimation using the equivalent age-compressive strength model. The maximum deviation of the prediction was within 10%, and the accuracy of the model was acceptable. This study provides a useful reference for the production of prefabricated MRC components in factories and subsequent construction.