Abstract
In order to enhance the fitness of the product and in order to improve productivity in turning operations, greater amount of challenges have been faced. In this paper, we have made a comparative analysis of HSS and carbide coated HSS drills while machining with H13 steel plates. For the drilling operation, process parameters were analysed using the Taguchi design of experiments. The response performance characteristics of surface roughness of H13 die steel plates for the drilling settings, cutting speed (rpm), and feed rate (mm/min) is optimized. The design of the experiment was conducted using the Taguchi technique for the L18 orthogonal array, and an analysis of variance was observed. The effect of drilling settings on the quality of drilled holes is examined; variation in surface roughness for various levels of speed and feed and the different combinations of these levels will form an L18 orthogonal array design of experiment by Taguchi analysis. A total of 36 cutting tests were performed with two different drill bits; here three different cutting speeds of 300, 600, and 900 rpm were taken with a feed rate of 0.02, 0.04, and 0.06 mm/rev combinations. The response of SN ratio for surface roughness of HSS and carbide tool has been found out for different levels of speed and feed. From this Taguchi analysis, it is identified that the optimal parameter. As a result, the factors are analysed, and optimized parameters have been concluded for H13 material using HSS, and carbide tools were examined both statistically and experimentally. The carbide coated drill bit gives 60% better surface roughness value based on experimental data obtained. The surface roughness value based on experimentation for HSS tool was found to be 34.16% and carbide coated drill bit was 23.40%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.