Abstract
The paper presents the results of metallographic and tribological studies of laser hardening zones of steel samples. A full factorial experiment on laser hardening with a change in the distance from the focal plane, radiation power and processing speed was carried out. The regularities of changes in the depth and width of the quenching zones are obtained from the regression equations. With low-frequency transverse scanning of the laser beam up to 100 Hz, the hardening zones with a width of 20 mm and a depth of 1.4-2.0 mm in one pass were obtained. The wear resistance of the hardened zones is 3.68 times higher than the base material.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.