Effects of laser and GMA hybrid welding parameters on shape, residual stress and deformation of HSLA steel welds

Abstract

Abstract As a high-efficiency and high-quality welding process, hybrid laser-MAG welding (HLMW) has significant potential of application in welding thick plates. In the present study, based on thermal elastic–plastic theory, a three-dimensional finite element model is developed to predict the weld shape characteristics, residual stress and distortion in HLMW for a butt joint of 12-mm-thick high strength steel plate. Metal active gas arc welding (MAG) heat input and laser energy are modeled as one double-ellipsoid body heat source and one cone body heat source with enhanced peak density along the central axis, respectively. The comparison between calculated molten pool shapes and those obtained by the experiment shows a good agreement. Then weld shape characteristic, residual stresses and distortions are calculated in four different welding process parameters. The results show that the increase of laser power and current can effectively increase the weld penetration width when the welding speed is fixed. At the top surfaces of weldment, the peak stress of high laser beam power is more significant than that of low laser beam power. A high compressive transverse stress of low laser beam power can be found at the welding zone and the surrounding heat affected zone. However, at the bottom surfaces of weldment, the peak stress of low laser beam power is larger than that of high laser beam power. The peak stress of low laser beam power is much larger than that of high laser beam power. A high compressive transverse stress of low laser beam power can be found at the welding zone. The vertical deformation in low laser beam power and low arc current welding has the lowest value.