Abstract
The present work suggests a mass-producible and large-scale fabrication method of superhydrophobic polymeric surfaces by means of material processing equipments which can maximize productivity and cost effectiveness. We fabricated two types of polymeric lotus leaf replicas using a nickel mold, i.e. R1 from intrinsically hydrophobic polydimethylsiloxane by means of polymer casting (PC) and R2 from an intrinsically hydrophilic UV-curable photopolymer by means of UV-nanoimprint lithography (UV-NIL). In the case of R1 from PC, although the nano-scaled structures were not well reproduced, the contact angle (CA) was remarkably high and the sliding angle (SA) was also close to that of the original lotus leaf, resulting in a superhydrophobic surface. In contrast to R1, in the case of R2 from UV-NIL, the nano-scaled structures as well as micro-scaled structures were also relatively well reproduced and the CA was increased noticeably by around 99° in comparison to a flat photopolymer. However, unexpectedly, the SA of R2 was much higher than that of R1. This work provides useful tips of polymeric material selection for the industrial mass production of the superhydrophobic polymer surface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.