Effects of inoculation amount and application method on the biodrying performance of municipal solid waste and the odor emissions produced

Abstract

The effects of inoculation amount and application method on the biodrying of municipal solid waste (MSW) was investigated in this study. Results showed that a low level (5%) of inoculation with mature compost significantly improved the biodrying index (4.96), while adding greater amounts decreased the biodrying performance by increasing the volatile solid degradation rate. Covering the pile with inoculation material resulted in the highest water removal (72.7%) and greatest water content reduction (from 60.2% to 17.7%). Meanwhile, first covering and then incorporating the inoculation material into the biodrying pile did not improve biodrying performance. Clearly, addition of varying amounts of inoculation material via different application methods enhanced cellulose degradation rates by 2.3–14.2%. Using 10% inoculation material reduced the NH3 emissions by 39.1–54.3% regardless of inoculation method, inoculation amount had a greater effect on NH3 emissions than that of inoculation method. The covering inoculation material could reduce 65.08% H2S emission, the inoculation method had a greater effect on H2S emissions than that of inoculation amount. Given the comprehensive considerations of emission reduction and biodrying performance, a covering of 10% inoculating material is a suitable approach to improve biodrying performance and mitigate odorous gases emissions.