Abstract
The effects of injection pressure on diesel particle physical and chemical properties were investigated on a heavy-duty diesel engine. Three injection pressures (600 bar, 800 bar, and 1000 bar) were selected at two engine loads (0.3 MPa BMEP and 0.9 MPa BMEP). The exhaust particle size distribution was measured by a scanning mobility particle sizer (SMPS). Consistent with previous studies, increasing injection pressure effectively removes accumulation mode particles, which results in a significant decrease in particle total mass concentration. The elemental carbon emission factors were then tested through organic carbon/element carbon (OC/EC) analysis. The emitted EC is decreased by 64% and 50% with increasing injection pressure from 600 bar to 1000 bar at the low and high engine loads, respectively. Particle morphology and oxidation reactivity were investigated by means of transmission electron microscope (TEM) imaging and thermogravimetric analysis (TGA) technology, respectively. Smaller primary particl...
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
