Abstract

AbstractWe have investigated effects of growth temperature of partial GaAs cap (Tcap) on InAs quantum dots (QDs) in indium‐flush (In‐flush) process with atomic force microscopy (AFM) and micro photoluminescence (μ‐PL) measurements. Tcap in In‐flush process are varied from 385 °C to 485 °C as an experimental parameter. In order to investigate the effects of Tcap on structural property of single InAs QD, shape of QD in initial capping process are characterized by AFM measurements in air at room temperature. While isotropic shape of QDs is kept in low Tcap conditions below about 440 °C, in‐plane anisotropy of initial shape of QDs are increased with increasing of Tcap due to elongation to the [1$ \bar 1 $0] direction. μ‐PL measurements are performed at 7K for the investigation of the effects of Tcap on optical property in single InAs QDs. In low Tcap conditions from 410 °C to 435 °C, distinct emissions from excitonic states in single QDs are observed. In the same Tcap range, the AFM result shows that isotropic shape of QDs is kept. On the other hand, in high Tcap conditions above about 440 °C, indefinite peaks and broad emissions appear remarkably. Excitonic emissions which are observed in low Tcap range are hardly observed in this high Tcap range (© 2011 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.