Effects of grain refinement and residual elements on hot tearing of A713 aluminium cast alloy

Abstract

Some investigations have been carried out on hot tears in the A713 cast alloy, which is one of the long freezing range alloys, with objective to minimize/prevent hot tears. Experiments were conducted by varying pouring temperatures at 700, 750, and 780 °C on the alloy with the addition of grain refiners like Al-2.5Ti-0.5C and Al-3.5Ti-1.5C. It was found that hot tearing was minimized by the addition of Al-3.5Ti-1.5C grain refiner, but grain refinement alone could not prevent hot tearing in A713 cast alloy. This has contradicted the findings of some earlier researchers. Experiments conducted on hot tearing with the addition of iron were found to be interesting. It was found that grain refinement along with iron addition to the A713 alloy has reduced the inter-dendritic separation so that interlocking could take place along the grain boundaries. Thus, iron, which comes as an impurity in commercial aluminum, can prevent hot tearing of A713 alloy.