Effects of fretting wear on rolling contact fatigue

Abstract

In this study, a three-dimensional (3D) continuum damage mechanics (CDM) finite element (FE) model was developed to investigate the effects of fretting wear on rolling contact fatigue (RCF) of bearing steels. In order to determine the fretting scar geometry, a 3D arbitrary Lagrangian-Eulerian (ALE) adaptive mesh (AM) FE model was developed to simulate fretting wear between two elastic bodies for different initially pristine fretting pressures (0.5, 0.75 and 1 GPa) and friction coefficients (0.15, 0.175 and 0.25) resulting in stick zone to contact width ratios, c/a = 0.35, 0.55 and 0.75. The resulting wear profiles were subjected to various initially pristine RCF pressures (1, 2.2 and 3.4 GPa). The pressure profiles for RCF were determined by moving the contact over the fretted wear profiles in 21 steps. These pressure profiles were then used in the CDM-FE model to predict the RCF life of fretted surfaces. The CDM-FE model uses Fatemi-Socie (FS) criteria for damage evolution and accounts for scatter in RCF life by implementing material topological variation through Voronoi tessellation. The results from CDM-FE RCF model indicate that fretting scar generated at 1 GPa with c/a = 0.35 has the most detrimental effect on RCF life at 1 GPa, reducing life by as much as 99.8% from pristine condition. However, it is to be noted that the remaining life expectancy at this RCF pressure (1 GPa) is significant and more than 17 billion cycles. As the RCF pressure increases (PRCF ≥ 2.2 GPa), the effect of fretting on RCF life decreases for all fretting pressures and c/a values, indicating that life is primarily governed by the RCF pressure. The results from CDM-FE model were also used to develop a life equation for evaluating the L10 life of fretted M-50 bearing steel for the range of tested conditions.