Abstract
Ethanol jet phenomena were observed with local contact microwave heating. The ethanol jet heights (velocities) and the shapes were measured by the high speed video camera (Redlake Motionmeter, 1000 fps. black & white CCD. 292pix×110pix, 0.2mm special resolution) and the effects of the exit diameter on the velocity were considered. The microwave output power was from 20W to 60 W. The microwave generator was MATSUSHITA TO-465 A with N-type connector. The coaxial cable was FUJIKURA 3.5 D QEFV (5.6 mm of outer diameter). The exit diameter was from 1 mm to 6 mm. The test section was covered by alumimum plates of 2 mm thickness and the microwave shader (Nisshinbo Engineering MP 135 R-20). The fuel chamber was brass. The jet shapes had many variations as fir tree type, umbrella type, mushroom type, and so on. As the results, the jet velocity was increased with the microwave output power and showed a maximum at an exit diameter in this research.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
