Effects of Enzyme Treatment and Carrier Agents on Chemical and Physical Properties of Almond Protein-Based Product

Abstract

There has been an emerging trend towards the research of plant-based proteins over the past few years; however, there has been limited conductive observation of plant-based proteins from almond by-products, as well as the potential of using Flavourzyme and different carrier agents to obtain an instant protein-based powder. The purpose of this study was to investigate the effects of Flavourzyme at various concentrations (0, 0.5, 1, 1.5, 2, and 2.5%) and incubation times (30, 60, 90, 120, and 180 min), as well as carrier agents at different ratios with a 20% total concentration on the physicochemical properties of almond protein-based products using freeze-drying (FD). The results showed a higher protein content (p-value ≤ 0.05) using 1.5% Flavourzyme for 120 min compared to the other levels. There was no significant difference (p-value > 0.05) in the protein retention rate after freeze-drying of the samples. However, the addition of Maltodextrin (MA), Gum Arabic (GA), and Inulin (IN) encapsulants improved the physical and functional characteristics of freeze-dried almond protein-based powder (FDAP). However, the solubility of the powder is moderate. Water-holding-capacity (WHC) and Oil- Holding Capacity (OHC) are inversely proportional, where GA-coated powder is the most hydrophobic (17.72 ± 0.87 mL oil/g) and IN-encapsulated powder is the most hydrophilic (15.00 ± 0.87 mL water/g). In conclusion, IN could be a potential encapsulant for almond protein-based powder, because powder produced from IN or MA: IN is acceptable in terms of physical parameters, and IN can also enhance fiber content in the final product.