Effects of electrolyte on the structure of pyrolytic graphite surfaces in anodic oxidation

Abstract

Anodic oxidation effects on the structure of the basal and edge surfaces of pyrolytic graphite in alkaline electrolytes have been studied. Laser Raman spectroscopy, a gas-phase chemical modification method, coupled with X-ray photoelectron spectroscopy and secondary ion-mass spectroscopy techniques, were used. Anodic oxidation of the surfaces of pyrolytic graphite in alkaline electrolytes does not cause destruction of their surface structure, even at a higher level of treatment, unlike oxidation of acid electrolytes. In alkaline electrolytes, the number of hydroxyl groups added on the edge surface gradually increases with the increase in treatment level, whereas the number of carboxyl groups does not increase. It was found that anodic oxidation in alkaline electrolytes has a wider permitted range of treatment, in which hydroxyl groups can be added without destroying the edge surface structure, than that found in acid electrolytes. On the other hand, the number of hydroxyl groups added by treating with alkaline electrolytes is smaller than that with acid electrolytes. At a higher treatment level with acid electrolytes, oxidation occurs, even to a depth of 40 nm from the edge surface, whereas with alkaline electrolytes, oxidation occurs only at the surface. On the basis of these results, the effects of electrolytes on the adhesion between carbon fibres and epoxy resin matrix are discussed.