Abstract
Emulsifiable oils are often used in posttensioned construction to reduce friction losses and provide temporary corrosion protection for tendons prior to grouting. This paper addresses the effects of two emulsifiable oils and three duct types on bond and friction losses. Bond test results indicate that corrugated galvanized steel ducts provide better anchorage than corrugated HDPE ducts. Rigid steel pipes performed poorly because of failure at the duct-concrete or grout-duct interface. Bond test results also indicate that the ultimate strength of posttensioned specimens with oiled tendons is similar to or better than the ultimate strength of specimens with unoiled tendons. However, specimens with oiled tendons experienced greater slip at a given load than specimens with unoiled tendons. Friction test results indicate that current recommended design values for the coefficient of friction for steel pipes and galvanized ducts are accurate. However, the measured coefficient for HDPE ducts is significantly less than the AASHTO-recommended value. Friction tests also indicate that lubrication of the tendon reduces the friction coefficient by 15% in rigid steel pipes and HDPE ducts if stressing occurs while the oil is fresh.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
