Abstract
Abstract In centrifugal pumps, it is important to select appropriate turbulence model for the numerical simulation in order to obtain reliable and accurate results. In this work, ten turbulence models in 3-D transient simulation for the centrifugal pump are chosen and compared. The pump performance is validated with experimental results. The numerical results reveal that the SST turbulence model was closer to the experimental results in predicting head. In addition, the pressure variation trend for the ten models is very similar which increases and then decreases from the inlet to outlet of the pump along the streamline. The SST k-ω model predicts the performance of the pump was more accurately than other turbulent models. Furthermore, the results also found that the error is the least at design operation condition 300(l/min), which is around 1.98 % for the SST model and 2.14 % and 2.38 % for the LES and transition omega model. Within 7.61 %, the errors at higher flow rate 350(l/min) for SST. The error for SST model is smaller as compared to different turbulent models. For the Realizable k-ɛ model, the errors fluctuate were more high than other models.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Nonlinear Sciences and Numerical Simulation
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.