Abstract
Graphite-silver (AgC) composite materials are widely used in outdoor high-voltage electrical switchgear due to their combining properties of excellent conductivity and outstanding arc-suppressing performance. However, the methods for fabricating AgC composite materials still have some limitations. In this study, the cold spray technique was adopted to deposit AgC composite coatings with the optimized parameters on the copper substrate. Then, AgC coatings were annealed in the furnace and treated by laser scanning, respectively, to further improve the arc erosion resistance performance of the coatings. The results show that the phase structure and electrical resistance of AgC coatings were not influenced by the post-treatment process. Furthermore, excellent hydrophobic performance was obtained after surface laser scanning treatment. The laser scanning treatment exhibited favorable advantages in enhancing the arc erosion resistance of AgC coatings, which indicated the lowest arc erosion rate compared with the cold-sprayed and annealed coatings.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.