Abstract

Simple SummaryBeef tenderness, flavour and juiciness are quality characteristics of consumer eating satisfaction. Marbling level of beef could determine quality characteristics by concentrating water soluble flavour molecules and releasing low fat-solubility volatiles faster. Increasing number of Holstein-Friesians bulls are used for beef production, and this breed is considered to have lower meat quality than purebred and crossbred beef cattle. Therefore, in this study we designed different dietary energy levels and slaughter ages to find ways to improve the meat quality of Holstein-Friesians bulls in beef production. We found that Holstein-Friesians bulls fed with 10.90 and 11.68 MJ/kg metabolizable energy diets, compared to a diet with 10.12 MJ/kg of metabolizable energy, had higher average daily gain, dressing percentage, intramuscular fat content and water holding capacity at 23 or 26 months of age. This study provides a basis to use bulls to produce beef by providing indicators of growth performance, rumen fermentation and ruminal bacteria community, and meat quality.The objective of this study was to evaluate the effects of dietary energy levels on growth performance, rumen fermentation and bacterial community, and meat quality of Holstein-Friesians bulls slaughtered at different ages. Thirty-six Holstein-Friesians bulls (17 months of age) were divided into a 3 × 3 factorial experiment with three energy levels (LE, ME and HE; metabolizable energy is 10.12, 10.90 and 11.68 MJ/kg, respectively) of diets, and three slaughter ages (20, 23 and 26 months). Results indicated that bulls fed with ME and HE diets had higher dry matter intake, average daily gain, and dressing percentage at 23 or 26 months of age. The ME and HE diets also reduced bacterial diversity, altered relative abundances of bacteria and produced lower concentrations of acetate, but higher butyrate and valerate concentrations in rumen fluid. Increasing in dietary energy and slaughter age increased the intramuscular fat (IMF) and water holding capacity. In summary, Holstein-Friesians bulls fed with ME and HE diets, slaughtered at 23 and 26 months of age could be a good choice to produce beef with high IMF. Slaughter age may have less influence than dietary energy in altering fermentation by increasing amylolytic bacteria and decreasing cellulolytic bacteria, and thus, further affecting meat quality.

Highlights

  • Beef tenderness, flavour and juiciness are quality characteristics of consumer eating satisfaction, of these, tenderness is the most important factor to affect the beef palatability [1,2]

  • Significant differences were observed in the body weight, dry matter intake (DMI), Average daily gains (ADG), and feed conversion ratio (FCR) among different dietary energy levels and ages (p < 0.05) (Table 2)

  • The DMI increased at 20 and 26 months of age with the increasing dietary energy, whereas the DMI of 23-month old bulls was lowest with ME diet

Read more

Summary

Introduction

Flavour and juiciness are quality characteristics of consumer eating satisfaction, of these, tenderness is the most important factor to affect the beef palatability [1,2]. Intramuscular fat (IMF) or marbling level is a characteristic appreciated by the consumer because of its positive effects on taste, tenderness and juiciness [3]. Marbling level of beef could determine quality characteristics by concentrating water soluble flavour molecules and releasing low fat-solubility volatiles faster [4,5]. The factors that affect the IMF deposition include breed, sex, slaughter weight and age, and nutrition [7]. Dietary factors, such as crude protein (CP) and carbohydrate, could affect rumen fermentation, digestibility, metabolism and meat quality [8,9]. There is a potential to increase the meat value of Holstein-Friesians bulls by increasing the killing out percentage that are suitable for the high-value markets

Objectives
Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call