Abstract
It has been proposed that the fracture toughness test provides an appropriate method for assessing the fracture resistance of the dentin-composite interface. The plane-strain fracture toughness test was therefore applied to a dentin-composite interface, with use of a specific dentinal adhesive, so that the effects of various dentin surface treatments on dentin-bond integrity could be studied. Interfacial fracture toughness (KIC) values were determined following 24h and 180 days of specimen aging in distilled water at 37 degrees C. Tensile bond strength (TBS) results following 24-hour aging were also obtained for comparison with the 24-hour KIC results. In general, the fracture resistance of the dentin-composite interface was highest when the dentin surface was conditioned with acid but not air-dried, intermediate when the dentin surface was conditioned with acid and subsequently air-dried, and lowest when the dentin was not conditioned with acid. The tensile bond strength results differed from the fracture toughness results in indicating differences in surface preparation effects and the type of interfacial failure observed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
