Effects of Cr-addition on ageing response of an Al–Si–Mg die cast alloy

Abstract

Chromium (Cr) is rarely added to Al–Si die cast alloys as it has a strong tendency to induce the formation of coarse-sized sludge particles. In the present study, high pressure die-cast samples made of Al-7wt.%Si–Cr–Mg alloys with varied Fe contents (0.11 wt%, 0.26 wt% and 0.32 wt%) were tensile tested under as-cast and T5 heat-treated conditions, in comparison to those made of Al-7wt.% Si–Mn–Mg alloy with a constant Fe content (0.11 wt%). The results demonstrated that under the as-cast condition, the Al–Si–Cr alloys with higher Fe contents can achieve comparable tensile properties as the Al–Si–Mn alloy with strictly controlled Fe level. However, after a T5 heat treatment (205 °C for 60 min), the increment in yield strength is less for the Al–Si–Cr alloys in relative to the Al–Si–Mn alloy, regardless of Fe contents. Scanning electron and scanning transmission electron microscopic characterizations were conducted on the as-cast and heat-treated microstructures, aiming to understand the undermined ageing response caused by Cr addition.