Abstract
Multi-walled carbon nanotubes (MWCNTs) were modified by corona discharge and then heat treated in the air. The influences of corona discharge parameters such as treatment time and processing power were investigated. The results of energy dispersive X-ray analysis (EDX) and thermogravimetric analysis (TGA) indicated the introduction of oxygen-containing functional groups onto the surface of the MWCNTs after heat treatment. The water contact angle tests showed that the hydrophobicity of the MWCNTs was decreased to some extent. The static water contact angle was reduced from 146° to 122° when the time of the corona discharge treatment reached 3 min at the processing power of 200 W. The enhanced thermomechanical and mechanical properties of epoxy nanocomposites filled with the corona discharge treated MWCNTs were observed. The modified MWCNTs conferred better properties on the composites than the pristine MWCNTs because of the improved dispersion of MWCNTs in matrix and the enhanced interfacial interaction between the treated MWCNTs and epoxy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
