Abstract
The objective of this experiment was to determine the effect of conditioning temperature and die speed on pellet quality and enzyme stability of phytase and xylanase. Treatments were initially arranged as a 2 × 3 factorial of conditioning temperature (74 and 85 °C) and die speed (127, 190, and 254 rpm); however, when conditioning at 85 °C, it was not possible to pellet at 127 rpm. Thus, data were analyzed in two different segments using the GLIMMIX procedure of SAS. First, linear and quadratic contrasts were utilized to test the response to increasing die speed at 74 °C. Second, the data was analyzed as a 2 × 2 factorial of conditioning temperature (74 and 85 °C) and die speed (190 and 254 rpm). Treatments were arranged in a completely randomized design and replicated three times. Diets were conditioned for approximately 30 s and pelleted with a 4.8-mm-diameter × 44.5-mm-effective length die at a rate of 4.5 MT/h. Pellet durability index (PDI) was determined using the tumble box and Holmen NHP 100 methods. Samples of the unconditioned mash (M), conditioned mash (CM), and pellets (P) were collected and analyzed for phytase and xylanase concentration. Relative enzyme stabilities were expressed as CM:M, P:CM, and P:M. Stabilities expressed as P:M were used an indication of enzyme stability through the entire pelleting process. Diets conditioned at 74 °C showed no evidence of difference in phytase or xylanase P:M stability when decreasing die speed from 254 to 127 rpm. However, when conditioning diets at 74 °C, decreasing die speed increased (linear, P < 0.001) PDI. There was no conditioning temperature × die speed interaction for overall xylanase P:M stability or PDI. However, there was a conditioning temperature × die speed interaction (P < 0.01) for phytase P:M stability. When conditioning diets at 85 °C, increasing die speed decreased phytase P:M stability. However, when conditioning at 74 °C, increasing die speed did not influence phytase P:M stability. For main effects of conditioning temperature, increasing temperature improved (P < 0.001) PDI with no evidence of difference for xylanase P:M stability. For the main effects of die speed (254 vs. 190 rpm), decreasing die speed decreased (P < 0.001) the P:M xylanase stability, but there was no evidence of difference for PDI. The results of this trial indicate that die speed should be taken into consideration when evaluating enzyme stability of both phytase and xylanase as pellet mill models may be operating at different speeds. Additionally, increasing conditioning temperature will improve PDI but may result in decreased phytase stability.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.