Effects of cold setting adhesives on properties of laminated veneer lumber from oil palm trunks in comparison with rubberwood

Abstract

In this study, the properties of laminated veneer lumber (LVL) made from oil palm trunks (OPT) were evaluated in comparison with rubberwood using cold setting adhesives, namely, emulsion polymeric isocyanate (EPI) and polyvinyl acetate (PVAc). The evaluations were based on either dry or after cold water, hot water and cyclic pre-treatment. The density of the OPT LVL was slightly higher than that of solid OPT. Thickness swelling and water absorption of OPT LVL were greater than of rubberwood LVL. Pre-treatment increased the water absorption and thickness swelling. The OPT LVL bonded with EPI without toluene showed greater water absorption and thickness swelling than EPI with toluene. Pre-treatment significantly reduced the tensile strength of OPT LVL. The OPT LVL bonded with EPI without toluene showed higher tensile shear strength, but a greater reduction of tensile shear strength after pre-treatment, than the OPT LVL bonded with EPI and toluene. The PVAc adhesive had greater wettability than the EPI. The EPI without toluene showed a lower contact angle than the EPI with toluene. The loose side of the OPT veneer was found to have greater wettability than the tight side.