Abstract
PurposeThe purpose of this study was to investigate the effects of deformation-induced martensite on electrochemical corrosion behaviors of 304 austenitic stainless steel in a simulated primary water environment of a pressurized water reactor nuclear power plant with boric acid and lithium hydroxide contaminated with chloride by potentiodynamic polarization, electrochemical impedance spectroscopy (EIS), Mott–Schotty curves and X-ray photoelectron spectroscopy (XPS).Design/methodology/approachThe effects of deformation-induced martensite transformation on electrochemical corrosion behaviors of 304 austenitic stainless steel was investigated in a simulated primary water environment of a pressurized water reactor nuclear power plant with boric acid and lithium hydroxide contaminated with 0.1 M Cl− by potentiodynamic polarization, EIS, Mott–Schotty curves and XPS in this paper.FindingsThe results revealed that the martensitic phase contents increased with the level of cold deformation. The general corrosion current density and the corrosion potential increased and decreased, respectively, with the increase of cold deformation degree. However, the pitting potential decreased as the cold deformation increased up to 20 per cent, then a slight increase was observed at 35 per cent cold working. It was found from Mott–Schottky curves and XPS analysis that as the cold deformation degree increased from 0 to 35 per cent, the doping concentrations of the oxide films increased; however, the film thickness decreased, which indicates that both density and integrity of the films are degraded significantly as the deformation degree increases, and this ultimately contributes to the significant increment of the general corrosion rate and reduction of the pitting corrosion resistance.Originality/valueThe effects of deformation-induced martensite transformation on electrochemical corrosion behaviors of 304 austenitic stainless steel was investigated in a simulated primary water environment of a pressurized water reactor nuclear power plant with boric acid and lithium hydroxide contaminated with 0.1 M Cl− by potentiodynamic polarization, EIS, Mott–Schotty curves and XPS in this paper.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
