Abstract
Ternary Ni‐Co‐P/TiN (20 nm) nanocomposite coatings with Co content in the range of 0–23 wt% were successfully co‐deposited on Al alloys by electroless plating. The morphology, composition, microstructure, micro‐hardness, wear behavior, and corrosion properties of the coatings were tested using SEM, EDS, XRD, Vickers hardness, ball‐on‐disc wear tester, and electrochemical workstation, respectively. The effect of Co content on the tribological and corrosion properties of Ni‐Co‐P/TiN coatings was studied. It is found that all the coatings have a compact and rough granular structure with sub‐micro globules non‐uniformly distributed on the surface. The grain size and the content of Ni and P decrease, but the micro‐hardness, adhesion force, friction coefficient, and corrosion resistance correspondingly enhance with the increase of Co content in Ni‐Co‐P/TiN coatings. The improved corrosion resistance of Ni‐Co‐P/TiN coating is due to the passivation behavior and small grain caused by the introduction of Co. Based on the excellent properties on the wear and corrosion resistance, ternary Ni‐Co23‐P/TiN coating with high Co content, may be applied as an optimum protective coating for Al alloys.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.