Abstract

An investigation was conducted into the impact of low cobalt content on the microstructure and mechanical properties of titanium alloys. Ti-4Al-6Cr-5Mo-8 Nb-xCo (x = 0, 2, 3, 4, and 5) alloys were prepared by ultrasonic-assisted melting and casting. The changes in microstructure, mechanical properties, and the strengthening and toughening mechanisms were researched. Results show that, when the cobalt content increases from 0 to 5 wt%, the as-cast structure is all β phase. The lattice parameter of the β phase decreases from 0.3663 to 0.3114 nm, a 15% decrease. The size of primary β grains decreases from 676.8 to 310.7 μm, a 54% decrease. When the cobalt content exceeds 3 wt%, the segregation energy of cobalt increases and grain boundary segregation occurs. Grain refinement is due to constitutional supercooling caused by the β-stable element cobalt, as well as the solute drag caused by the differences in intragranular and grain boundary compositions. In addition, the size mismatch between cobalt and titanium atoms leads to lattice distortion. As the cobalt content increases from 0 to 3 wt%, the tensile strength increases from 918.1 to 1147.8 MPa, a 25% increase, while the fracture toughness increases from 51.7 to 59.7 MPa·m1/2, a 15% increase. At 5 wt% cobalt, the tensile strength and fracture toughness diminished to 247.5 MPa and 14.8 MPa·m1/2, respectively. The decrease in lattice parameters mainly lead to an increase in strength. The secondary crack leads to an increase in toughness. The decline in strength and toughness results from cobalt segregating at grain boundaries, leading to embrittlement.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call