Effects of cleansing methods on 3-D surface roughness, gloss and color of a polyamide denture base material

Abstract

Objective. The purpose of this study was to determine the effects of two denture cleansing methods on 3-D surface roughness, gloss and color of denture base materials. Materials and methods. Thirty disks from nylon (Valplast) and 30 from heat-polymerized acrylic denture base material (Paladon 65) were made and 10 of each material were immersed in water (control), Val-Clean (peroxide cleanser) and Corega Extradent (peroxide cleanser) plus microwaving for a period simulating 30 days of daily cleansing. 3-D surface roughness, gloss and color parameters were measured before and after cleansing using an interferometric profilometer, a gloss meter and a colorimeter. The results were statistically analysed by regression, paired-t, Mann-Whitney and Kruskal-Wallis tests at α = 0.05 level of significance. Results. The results showed significant differences at baseline in L* and b* parameters between materials (p < 0.01), with a significantly lower gloss (p < 0.05) and higher roughness (p < 0.05) for Valplast. After cleansing, Δε* was significantly greater in Valplast than Paladon 65 (p < 0.05). Gloss of both materials decreased significantly within the Corega Extradent plus microwave solution (p < 0.05), while roughness increased significantly only for Paladon 65 (p < 0.05). Conclusions. Valplast was found to have a significantly lower gloss and a higher roughness than Paladon 65 before cleansing. After cleansing, ΔE* increased more in Valplast than in Paladon 65, gloss of both materials decreased and roughness only of Paladon 65 increased within the Corega extradent plus microwaving method.