Effects of blood viscosity on proximal flow convergence calculations of regurgitant flow rate and jet dimensions as evaluated by color Doppler flow mapping: An in vitro study

Abstract

There are limited data on the potential influence of blood viscosity on the quantification of valvular regurgitation by color Doppler in the clinical setting. This study was designed to evaluate the effects of blood viscosity on jet dimensions and the proximal flow convergence (proximal isovelocity surface area, PISA) method of estimating valvular insufficiency severity. We used an in vitro flow model filled with human blood at varying hematocrits (15%, 35%, and 55%) and blood viscosity (blood/water viscosity: 2.6, 4.8, 9.1) in which jets were driven through a known orifice (16 mm2) into a 110-mL compliant receiving chamber (compliance: 2.2 mL/mm Hg) by a power injection pump. Blood injections (2 and 4 mL) at flow rates of 4, 6, 8, 10, and 12 mL/s were performed. Proximal flow convergence and spatial distribution of jets were imaged by a 3.5-MHz transducer. Pressure and volume in the flow model were kept constant before each injection. Ultrasound settings were the same for all experiments. Jet area decreased significantly with increasing blood viscosity, but the difference in jet dimensions was much larger for lower than for higher flow rates and for highest blood viscosity. Estimation of flow rate by the PISA method was not significantly influenced by blood viscosity. Blood viscosity has a major influence in jet area, especially for lower flow rates, but did not change significantly the grading of regurgitation by the PISA method. Thus this factor should be considered for determining the method of choice when quantification of valvular regurgitation is performed in patients with anemia or polycythemia. (J Am Soc Echocardiogr 2001;14:569-79.)