Effects of binder droplet size and powder particle size on binder jetting part properties

Abstract

PurposeIn binder jetting, the interaction between the liquid binder droplets and the powder particles defines the shape of the printed primitives. The purpose of this study is to explore the interaction of the relative size of powder particles and binder droplets and the subsequent effects on macro-scale part properties.Design/methodology/approachThe effects of different particle size distribution (5–25 µm and 15–45 µm) of stainless steel 316 L powders and droplet sizes (10 and 30 pL) on part density, shrinkage, mechanical strength, pore morphology and distribution are investigated. Experimental samples were fabricated in two different layer thicknesses (50 and 100 µm).FindingsWhile 15–45 µm samples demonstrated higher green density (53.10 ± 0.25%) than 5–25 µm samples (50.31 ± 1.06%), higher sintered densities were achieved in 5–25 µm samples (70.60 ± 6.18%) compared to 15–45 µm samples (65.23 ± 3.24%). Samples of 5–25 µm also demonstrated superior ultimate tensile strength (94.66 ± 25.92 MPa) compared to 15–45 µm samples (39.34 ± 7.33 MPa). Droplet size effects were found to be negligible on both green and sintered densities; however, specimens printed with 10-pL droplets had higher ultimate tensile strength (79.70 ± 42.31 MPa) compared to those made from 30-pL droplets (54.29 ± 23.35 MPa).Originality/valueTo the best of the authors’ knowledge, this paper details the first report of the combined effects of different particle size distribution with different binder droplet sizes on the part macro-scale properties. The results can inform appropriate process parameters to achieve desired final part properties.