Abstract
The aim of the research was to evaluate the lapping length, the adhesive bonded surface treatment and the influence of the filler in the form of the aluminium microparticles on the adhesive bond strength. The alloy AlCu4Mg was the adhesive bonded material bonded by means of a two-component epoxy adhesive used in construction of machines. The filler in a form of aluminium microparticles was added into the adhesive. Laboratory experiments were performed on normalized testing samples of alloy AlCu4Mg prepared under standard CSN EN 1465. Within the research three various treatments of the adhesive bonded surface were evaluated, i.e. without the surface treatment (WT), mechanical treatment of the surface (MT) and mechanical and chemical treatment of the surface (MCHT). The adhesive bonds without the adhesive bonded surface treatment (marked as WT) reach the smallest adhesive bond strength. When adding the filler in the form of aluminium microparticles (10 vol. %) the adhesive bond strength was increased of about 12%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
