Abstract
ABSTRACTThe effects of the alloying elements of Cr, Mn and the cooling rates after hot deformation on the microstructures and mechanical properties of pearlite steels were studied. Results show that increasing Cr and decreasing Mn significantly increase the eutectoid transformation temperature of steel. The grain sizes of prior austenite of the steels after hot deformation are ∼12 µm. However, the high-Cr–low-Mn steel exhibits a finer interlamellar spacing and some better mechanical properties than that of the high-Mn–low-Cr steel. A full pearlite microstructure with an interlamellar spacing of 97 nm was obtained on the former steel, which exhibits a hardness of HRC49, a tensile strength of 1700 MPa and an elongation of 19%.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
